Experiment 01: Verification of Ohm’s Law and Resistivity
Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.
1. Objective
To study and experimentally verify experiment 01: verification of ohm’s law and resistivity using instructor-approved apparatus and measured observations.
2. Theory
Ohm’s law states that, for a conductor maintained at constant physical conditions (especially temperature), current is directly proportional to the potential difference across it: V = IR. The resistance is R = V/I. For a uniform wire, R = ρL/A, so resistivity is ρ = RA/L.
3. Apparatus
Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.
4. Circuit diagram
Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.
5. Procedure
Measure the wire length L and diameter d at several positions; calculate A = πd²/4. Connect the circuit with the ammeter in series and voltmeter in parallel with the test resistor/wire. Begin with the supply at zero and use a current-limiting resistor. Increase the voltage in small steps, recording V and I. Do not allow the wire to heat noticeably. Calculate R for each reading and plot V against I; the slope is R.
6. Observation table
| Reading | V (V) | I (A) | R = V/I (Ω) |
|---|---|---|---|
| 1 | |||
| 2 | |||
| 3 | |||
| 4 |
7. Calculations
From the V–I graph, R = ΔV/ΔI. Then ρ = RA/L. Report units and uncertainty/measurement limitations. Do not invent readings; enter measured values from the actual bench.
8. Result and discussion
The V–I graph should be approximately a straight line through the origin for an ohmic conductor. Sources of error include contact resistance, instrument zero error, wire heating and diameter measurement.
9. Precautions
- Switch off the supply before wiring or changing connections.
- Check polarity, meter mode, range and component ratings before switching on.
- Use current limiting and begin with the lowest practical source setting.
- Never connect an ammeter in parallel with a source; never short an unknown source.
- Record actual readings with units; do not fabricate observation values.
- Follow the instructor's bench-safety directions and the component datasheets.
10. Viva voce
- State Ohm’s law. 2. Why is the ammeter connected in series? 3. Why is the voltmeter connected in parallel? 4. Define resistivity and give its SI unit. 5. Why should current be kept low?
Short answers
The ammeter has very low internal resistance and is placed in series; the voltmeter has high internal resistance and is placed in parallel. Resistivity is a material property measured in Ω·m. A changing temperature can change resistance, invalidating a simple constant-R test.
Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.