Experiment 03: Verification of Thevenin’s Theorem
Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.
1. Objective
To study and experimentally verify experiment 03: verification of thevenin’s theorem using instructor-approved apparatus and measured observations.
Thevenin’s theorem states that a linear two-terminal network can be replaced, as seen by a load, by an ideal voltage source Vth in series with a resistance Rth. Vth is the open-circuit terminal voltage. For independent sources, Rth is found by deactivating ideal voltage sources (short circuit) and ideal current sources (open circuit), then looking into the terminals.
3. Apparatus
Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.
4. Circuit diagram
Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.
5. Procedure
Assemble the assigned linear DC network. Identify the load terminals and measure open-circuit voltage Vth with the load removed. Turn off the supply before changing connections. Deactivate independent sources correctly and measure/calculate Rth looking into the load terminals. Reconnect a known load RL and measure load voltage/current. Compare with the Thevenin equivalent prediction. Follow instructor-approved circuit and supply limits.
6. Observation table
| RL (Ω) | Vload measured (V) | Iload measured (A) | Vload predicted (V) |
|---|---|---|---|
7. Calculations
Iload(predicted) = Vth/(Rth + RL); Vload(predicted) = Iload × RL. Compare measured and predicted values and calculate percentage difference when the predicted value is non-zero.
8. Result and discussion
The measured load response should approximately match the Thevenin equivalent. Dependent sources, if present, must remain active; use a test source to determine Rth rather than turning dependent sources off.
9. Precautions
- Switch off the supply before wiring or changing connections.
- Check polarity, meter mode, range and component ratings before switching on.
- Use current limiting and begin with the lowest practical source setting.
- Never connect an ammeter in parallel with a source; never short an unknown source.
- Record actual readings with units; do not fabricate observation values.
- Follow the instructor's bench-safety directions and the component datasheets.
10. Viva voce
- Define Vth. 2. How is Rth found? 3. What happens to an ideal voltage source when deactivated? 4. What happens to an ideal current source? 5. Does the theorem apply to nonlinear networks in general?
Short answers
An ideal voltage source is replaced by a short circuit and an ideal current source by an open circuit. The basic theorem applies to linear two-terminal networks.
Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.