Skip to content

Experiment 04: Verification of Norton’s Theorem

Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.

1. Objective

To study and experimentally verify experiment 04: verification of norton’s theorem using instructor-approved apparatus and measured observations.

Norton’s theorem states that a linear two-terminal network can be replaced by an ideal current source IN in parallel with a resistance RN. IN is the short-circuit current at the terminals and RN = Rth for the same network.

3. Apparatus

Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.

4. Circuit diagram

Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.

5. Procedure

Build the assigned linear network. Remove the load and measure short-circuit current only using the instructor-approved current-measurement setup and meter range; never short an unknown source directly. Determine RN by deactivating independent sources as appropriate, or obtain it from Rth. Reconnect RL and compare the measured load current with the Norton-equivalent prediction.

6. Observation table

RL (Ω) Iload measured (A) Iload predicted (A) Vload measured (V)

7. Calculations

Iload = IN × RN/(RN + RL). Also Vload = Iload × RL. Since RN = Rth, IN = Vth/Rth for a valid equivalent.

8. Result and discussion

Measured and predicted load responses should agree within component and instrument tolerances. Errors may arise from meter burden voltage, resistor tolerance and incorrect terminal identification.

9. Precautions

  • Switch off the supply before wiring or changing connections.
  • Check polarity, meter mode, range and component ratings before switching on.
  • Use current limiting and begin with the lowest practical source setting.
  • Never connect an ammeter in parallel with a source; never short an unknown source.
  • Record actual readings with units; do not fabricate observation values.
  • Follow the instructor's bench-safety directions and the component datasheets.

10. Viva voce

  1. Define Norton current. 2. State the relation between RN and Rth. 3. How is IN determined? 4. What is the Norton equivalent circuit? 5. How are Thevenin and Norton forms related?

Short answers

IN is the short-circuit current at the output terminals. RN equals Rth. Thevenin and Norton forms are source transformations of the same linear two-terminal network.


Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.