Skip to content

Experiment 05: Verification of Superposition Theorem

Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.

1. Objective

To study and experimentally verify experiment 05: verification of superposition theorem using instructor-approved apparatus and measured observations.

In a linear circuit with multiple independent sources, the voltage or current in any element equals the algebraic sum of the contributions produced by each independent source acting alone. When considering one source, deactivate the other independent ideal voltage sources by shorting them and ideal current sources by opening them. Dependent sources remain active.

3. Apparatus

Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.

4. Circuit diagram

Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.

5. Procedure

Construct the assigned linear resistive circuit with at least two independent sources. Measure the selected branch current/voltage with all sources active. Then consider one independent source at a time, deactivating the others correctly, and record the signed contribution. Restore the original circuit between tests. Add contributions algebraically and compare with the all-source measurement.

6. Observation table

Condition Signed branch current (A) or voltage (V)
All sources active
Source 1 only
Source 2 only
Algebraic sum

7. Calculations

Result from superposition = contribution 1 + contribution 2 (+ further contributions). Percentage difference = |measured − sum|/|measured| × 100 when measured is non-zero.

8. Result and discussion

The algebraic sum should be close to the all-source measurement. Superposition applies to linear voltage/current responses, not directly to power because power is nonlinear in voltage/current.

9. Precautions

  • Switch off the supply before wiring or changing connections.
  • Check polarity, meter mode, range and component ratings before switching on.
  • Use current limiting and begin with the lowest practical source setting.
  • Never connect an ammeter in parallel with a source; never short an unknown source.
  • Record actual readings with units; do not fabricate observation values.
  • Follow the instructor's bench-safety directions and the component datasheets.

10. Viva voce

  1. State the superposition theorem. 2. How is an ideal voltage source deactivated? 3. How is an ideal current source deactivated? 4. Are dependent sources deactivated? 5. Can power be superposed directly?

Short answers

Keep dependent sources active. Do not add individual powers to obtain total power; first find the total voltage/current, then calculate power.


Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.