Skip to content

Experiment 06: Study of an RC Circuit and Time Constant

Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.

1. Objective

To study and experimentally verify experiment 06: study of an rc circuit and time constant using instructor-approved apparatus and measured observations.

An RC circuit contains a resistor R and capacitor C. Its time constant is τ = RC seconds. During charging from a DC step, capacitor voltage is vc(t) = Vs(1 − e^(−t/RC)); during discharging from V0, vc(t) = V0e^(−t/RC). After one time constant, charging reaches about 63.2% of its final value and discharging falls to about 36.8% of its initial value.

3. Apparatus

Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.

4. Circuit diagram

Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.

5. Procedure

Use a low-voltage source, known resistor and capacitor with correct polarity for an electrolytic capacitor. Connect the circuit as directed by the instructor. Measure capacitor voltage at regular time intervals during charging and discharging. Discharge the capacitor safely through a resistor before handling or changing the circuit. Never short capacitor terminals directly.

6. Observation table

Time t (s) Charging vc (V) Discharging vc (V)
0
τ
2τ
3τ
4τ

7. Calculations

Theoretical τ = RC. Experimental τ can be estimated as the charging time to 0.632Vs or discharging time to 0.368V0. Compare theoretical and experimental values.

8. Result and discussion

The voltage changes exponentially, not linearly. Timing resolution, capacitor tolerance, leakage and meter input resistance affect the result.

9. Precautions

  • Switch off the supply before wiring or changing connections.
  • Check polarity, meter mode, range and component ratings before switching on.
  • Use current limiting and begin with the lowest practical source setting.
  • Never connect an ammeter in parallel with a source; never short an unknown source.
  • Record actual readings with units; do not fabricate observation values.
  • Follow the instructor's bench-safety directions and the component datasheets.

10. Viva voce

  1. Define time constant. 2. Give the unit of τ. 3. What percentage is reached after one τ during charging? 4. What remains after one τ during discharging? 5. Why use a resistor to discharge a capacitor?

Short answers

τ = RC and is measured in seconds. A resistor limits discharge current and reduces the risk of a damaging spark or component stress.


Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.