Experiment 07: Study of RLC Series Resonance
Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.
1. Objective
To study and experimentally verify experiment 07: study of rlc series resonance using instructor-approved apparatus and measured observations.
In a series RLC circuit, resonance occurs when inductive and capacitive reactances are equal: XL = XC. The resonant frequency is f0 = 1/(2π√LC). At ideal series resonance, impedance is minimum (approximately R), current is maximum, and power factor is unity.
3. Apparatus
Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.
4. Circuit diagram
Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.
5. Procedure
Assemble the series RLC circuit using instructor-approved components and signal-generator limits. Keep the input amplitude within component ratings. Sweep frequency in controlled steps around the calculated f0, measuring circuit current and voltage. Record the frequency at which current is maximum. Avoid touching components while powered and switch off before rewiring.
6. Observation table
| Frequency (Hz) | Supply voltage (V) | Current (A) |
|---|---|---|
7. Calculations
Calculate f0 = 1/(2π√LC) using measured/labelled L and C. Plot current against frequency and identify the peak. Compare theoretical and observed resonance frequencies.
8. Result and discussion
The current peak should occur near f0. Coil resistance, component tolerances, parasitic effects and instrument loading shift or broaden the peak.
9. Precautions
- Switch off the supply before wiring or changing connections.
- Check polarity, meter mode, range and component ratings before switching on.
- Use current limiting and begin with the lowest practical source setting.
- Never connect an ammeter in parallel with a source; never short an unknown source.
- Record actual readings with units; do not fabricate observation values.
- Follow the instructor's bench-safety directions and the component datasheets.
10. Viva voce
- Define resonance. 2. Write the resonant-frequency formula. 3. What is the impedance at ideal series resonance? 4. What is the power factor? 5. What happens to current at resonance?
Short answers
At series resonance XL = XC, net reactance is zero, impedance is minimum and current is maximum. The ideal power factor is one.
Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.