Skip to content

Experiment 08: Study of the V–I Characteristics of a PN Junction Diode

Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.

1. Objective

To study and experimentally verify experiment 08: study of the v–i characteristics of a pn junction diode using instructor-approved apparatus and measured observations.

A PN junction diode conducts readily when forward biased after the applied voltage overcomes the junction barrier; in reverse bias only a small leakage current flows until breakdown. The forward and reverse V–I characteristics are not symmetric. Silicon diodes commonly show a forward drop around 0.6–0.7 V at modest currents, but the value depends on current and temperature.

3. Apparatus

Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.

4. Circuit diagram

Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.

5. Procedure

Identify the diode terminals and verify the part number. Connect a current-limiting resistor in series. Record forward voltage and current at small, safe increments. Turn off the supply and reverse the diode to obtain reverse-bias readings using a suitable microammeter/range and a voltage within the diode rating. Do not approach breakdown unless the instructor explicitly specifies a protected Zener/breakdown experiment.

6. Observation table

Bias Diode voltage (V) Diode current (mA or µA)
Forward
Forward
Reverse

7. Calculations

Plot forward and reverse characteristics separately, with clearly labelled axes and units. Identify the approximate forward knee region from measured data. Do not infer a breakdown voltage unless safely measured within the device rating.

8. Result and discussion

Forward current rises rapidly after the knee region; reverse current remains small before breakdown. Heating and meter resolution can affect readings.

9. Precautions

  • Switch off the supply before wiring or changing connections.
  • Check polarity, meter mode, range and component ratings before switching on.
  • Use current limiting and begin with the lowest practical source setting.
  • Never connect an ammeter in parallel with a source; never short an unknown source.
  • Record actual readings with units; do not fabricate observation values.
  • Follow the instructor's bench-safety directions and the component datasheets.

10. Viva voce

  1. What is forward bias? 2. What is reverse bias? 3. Why is a series resistor used? 4. What is reverse leakage current? 5. Does a normal diode behave like an ideal switch?

Short answers

A series resistor limits current and protects the diode. Never connect a diode directly to a supply without suitable current limiting.


Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.