Skip to content

Experiment 09: Input and Output Characteristics of a BJT (CB/CE)

Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.

1. Objective

To study and experimentally verify experiment 09: input and output characteristics of a bjt (cb/ce) using instructor-approved apparatus and measured observations.

A bipolar junction transistor has emitter, base and collector terminals. In common-emitter (CE), the emitter is common to input and output; in common-base (CB), the base is common. Input characteristics relate input current to input voltage at constant output voltage/current condition; output characteristics relate output current to output voltage for fixed input-current steps.

3. Apparatus

Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.

4. Circuit diagram

Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.

5. Procedure

Use the exact transistor pinout from its datasheet; pin arrangements vary. Build the CB or CE test circuit using the instructor's low-voltage, current-limited setup. Set bias controls to minimum before powering. Increase base/emitter input in small steps, recording the corresponding input and output quantities. Do not exceed maximum ratings. Power off before changing connections.

6. Observation table

Configuration Control setting Input voltage/current Output voltage/current
CE IB = VBE = VCE = ; IC =
CB IE = VEB = VCB = ; IC =

7. Calculations

Plot the appropriate input and output characteristic curves. In CE, current gain β ≈ ΔIC/ΔIB at constant VCE. In CB, current gain α ≈ ΔIC/ΔIE at constant VCB. Use measured slopes in the active region.

8. Result and discussion

The curves distinguish cutoff, active and saturation regions. Device variation, temperature and incorrect pinout can produce misleading readings.

9. Precautions

  • Switch off the supply before wiring or changing connections.
  • Check polarity, meter mode, range and component ratings before switching on.
  • Use current limiting and begin with the lowest practical source setting.
  • Never connect an ammeter in parallel with a source; never short an unknown source.
  • Record actual readings with units; do not fabricate observation values.
  • Follow the instructor's bench-safety directions and the component datasheets.

10. Viva voce

  1. Name the three BJT terminals. 2. Define α and β. 3. Which region is used for amplification? 4. What is cutoff? 5. Why must the datasheet pinout be checked?

Short answers

The active region is used for amplification. Cutoff is the near-off state; saturation is the strongly-on state. α and β are current gains under specified conditions.


Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.