Skip to content

Experiment 10: Study of Zener Diode V–I Characteristics

Student lab-note template · Verify the experiment order and circuit diagram against your department's current lab manual.

1. Objective

To study and experimentally verify experiment 10: study of zener diode v–i characteristics using instructor-approved apparatus and measured observations.

A Zener diode is designed to operate in reverse breakdown within its rated current and power limits. In the breakdown region, its voltage remains approximately VZ over a range of reverse current. A series resistor is essential to limit current. Power dissipation is PZ = VZIZ.

3. Apparatus

Use the apparatus specified by your instructor and the actual circuit diagram supplied in the lab. Typical items may include a regulated low-voltage DC supply or signal generator, breadboard/trainer board, appropriate resistors/components, connecting leads and correctly ranged meters. Check every component's rating before energizing the circuit.

4. Circuit diagram

Insert or draw the exact circuit from your current lab manual here. Label component values, polarities, meter positions, source settings and current directions. Do not treat a generic diagram as a substitute for the instructor's circuit.

5. Procedure

Identify the Zener voltage and power rating from the datasheet. Connect the Zener in reverse bias with a suitable series resistor and a current-limited supply. Increase input voltage slowly while monitoring Zener voltage and current. Keep IZ and PZ below the manufacturer's limits. Record forward-bias behaviour only if instructed. Switch off before changing the circuit.

6. Observation table

Input voltage (V) Zener voltage VZ (V) Zener current IZ (mA)

7. Calculations

Calculate PZ = VZ × IZ. Plot reverse current against Zener voltage and identify the approximate regulation region. Never exceed the datasheet maximum power or current.

8. Result and discussion

In breakdown, voltage changes relatively little while current changes more. Series resistance, temperature and device tolerance affect regulation.

9. Precautions

  • Switch off the supply before wiring or changing connections.
  • Check polarity, meter mode, range and component ratings before switching on.
  • Use current limiting and begin with the lowest practical source setting.
  • Never connect an ammeter in parallel with a source; never short an unknown source.
  • Record actual readings with units; do not fabricate observation values.
  • Follow the instructor's bench-safety directions and the component datasheets.

10. Viva voce

  1. What is Zener breakdown? 2. Why is a series resistor necessary? 3. Define Zener voltage. 4. How is Zener power calculated? 5. Can any ordinary diode safely be used as a Zener regulator?

Short answers

A Zener regulator uses reverse breakdown of a suitably rated Zener diode. The series resistor limits current; the diode's power rating must not be exceeded.


Academic integrity: This is a study/report template, not an official NU-issued experiment sheet. Fill in your own circuit diagram, actual readings, calculations and instructor-required format. The repository's experiment list is based on an older syllabus reference and must be checked against the current lab manual.